The Norwex Microfiber Car Mitt does it all for washing the exterior of your car, and is the perfect gift for car enthusiasts!

One side of the Car Mitt is chenille microfiber (tufted little microfiber fingers), and the other side is microfiber with a sponge layer.

•         The dirt and debris that is collected easily washes out with just a rinse with a hose or bucket.

•         Holds soap and water well.

•         Does not collect dirt and grit and is designed to reduce chance of scratching vehicle paint surfaces.

•         Gently lifts dirt and washes away grime.

Hints, tips and how-to's:

•         Before washing make sure that the car is in the shade and the paint surface is relatively cool. If you can comfortably hold your hand on the hood, it is a good temperature to wash/wax the car.

•         Spray the entire car with a gentle spray to thoroughly wet the surface.  Work from the top down; re-wetting, washing, and rinsing each section as you go. This way soap or dirty water does not dry onto the paint.

•         Car enthusiasts will prefer the new Norwex Car Mitt to other car washing methods.

•         When rinsing the mitt in the wash bucket rinse well, and every so often hold the top open, allowing it to fill with water. Then lift straight up. As the water runs out, the mitt “back-flushes” the trapped dirt from the mitt.

•         The flat surface of a traditional sponge can sometimes catch dirt and act like sandpaper; the Norwex Car Mitt allows grit to work up into the long fibers to reduce the risk of scratching the paint during washing.

•         Serious car enthusiasts will prefer two wash mitts - one for the top half of the car (the cleanest part) and one for below the trim line and wheels.